Grandstream Networks UCM6510 IP PBX - Page 142

Firmware Version 1.0.1.12
UCM6510 IP PBX User Manual
Page 140 of 277
indicate the E.164 number. If set to "Enable", "Tel:" will be used instead of
"SIP:" in the SIP request. The default setting is disabled.
Username
Enter the username to register to the trunk from the provider when
"Register SIP Trunk" type is selected.
Password
Enter the password to register to the trunk from the provider when
"Register SIP Trunk" is selected.
Auth ID
Enter the Authentication ID for "Register Trunk" type.
Outbound Proxy
Enter the IP address or URL of the outbound proxy for "Register SIP
Trunk" type.
Auto Record
Enable automatic recording for the calls using this trunk (for SIP trunk
only). The default setting is disabled. The recording files are saved in
external storage if plugged in and can be accessed under web
GUI->CDR->Recording Files.
Peer SIP Trunk Configuration Parameters
Provider Name
Configure the provider name for the VoIP trunk. This is a unique label to
identify the trunk when listed in outbound rules, inbound rules and etc.
Host Name
Configure the IP address or URL for the VoIP provider server of the trunk.
Transport
Configure the SIP transport protocol to be used in this trunk. The default
setting is "All - UDP Primary".
 UDP Only
 TCP Only
 TLS Only
 All - UDP Primary: UDP is the primary transport protocol when all the
other SIP transport methods are available too.
 All - TCP Primary: TCP is the primary transport protocol when all the
other SIP transport methods are available too.
 All - TLS Primary: TLS is the primary transport protocol when all the
other SIP transport methods are available too.
Keep Trunk CID
If enabled, the trunk CID will not be overridden by extension's CID when
the extension has CID configured. The default setting is "No".
Disable This Trunk
If selected, the trunk will be disabled.
TEL URI
If the end device/phone has an assigned PSTN telephone number, this
field should be set to "User=Phone". Then a "User=Phone" parameter will
be attached to the Request-Line and TO header in the SIP request to
indicate the E.164 number. If set to "Enable", "Tel:" will be used instead of
"SIP:" in the SIP request. The default setting is disabled.
Caller ID
Configure the Caller ID. This is the number that the trunk will try to use
when making outbound calls. For some providers, it might not be possible