H3C WA Series User Manual

335
Configuring the AP
1. Assign an IP address to the fat AP:
a. Select Network > VLAN to create a VLAN on the fat AP.
b. Select Device > Interface Management to assign an IP address to the VLAN interface.
2. Configure a wireless service
a. Select Wireless Service > Access Service from the navigation tree.
b. Click Add.
c. On the page that appears, set the service name to 11nservice, select the wireless service type
clear, and click Apply.
Figure 360 Create a wireless service
3. Bind an AP radio to a wireless service
a. Select Wireless Service > Access Service from the navigation tree.
b. Click the Bind link at the right side of the wireless service 11nservice to enter the page as shown
in Figure 361.
c. Selec
t the box with radio mode 802.11n(2.4GHz).
d. Click Bind.
Figure 361 Bind an AP radio
4. Enable the wireless service
a. Select Wireless Service > Access Service from the navigation tree.
b. On the page that appears, select the 11nservice box.
c. Click Enable.

H3C WA Series Specifications

General

Brand	H3C
Model	WA Series
Category	Wireless Access Point
Language	English