6. Click Apply. The task is now registered. If the Go to tasks window for
status check box is checked, the Task window opens to show the status
of the task.
Backing up HDvM - SN configuration files
Before replacing an SVP, you must make a backup copy of the Device
Manager - Storage Navigator configuration files on the SVP. You can then use
the backup copy to restore the configuration file if it becomes necessary, or
to configure a replacement SVP if one fails.
The following configuration items can be backed up and restored. Before you
create the backup, ensure that the settings are correct.
• Device Manager - Storage Navigator environment parameters
• Authentication server connection settings
• Key management server connection settings
• Password policy when backing up the management client encryption key
• Display settings (table width) for each Device Manager - Storage Navigator
user
• Device Manager - Storage Navigator login warning messages
• Device Manager - Storage Navigator task information
• SMI-S application settings
• SSL certification for HTTPS/SMI-S/RMI
Before you begin
• You must have the Storage Administrator (Initial Configuration) role to
perform this task.
• You must be logged into the SVP.
Procedure
1. Stop all services running on the storage system.
2. Open a command prompt window with administrator permissions.
3. In the folder where the .bat file is located, execute the following
command:
C:\MAPP\wk\Supervisor\MappIniSet>MappBackup.bat absolute-
path-of-backup-file
Note:
• The backup file must be in .tgz format.
• A space is required between .bat file and the path to the backup
file.
4. A completion message displays. Click any key to continue.
5. Close the command prompt window.
Configuring the storage system 119
System Administrator Guide for VSP Gx00 models and VSP Fx00 models
To Next Page
Loading...
Need help?
General