Hitachi VSP G400 System Administration Guide

Audit log settings
This section shows the procedures to configure the audit log settings.
The Audit Log Settings window shows the current audit log settings. Select
one of more of the three tabs to change the settings.
Related tasks
• Setting up a syslog server on page 272
• Exporting an audit log on page 273
• Sending a test Syslog message on page 251
Setting up a syslog server
Before you begin
You must have the Audit Log Administrator (View & Modify) role to perform
this task.
Procedure
1. In the maintenance utility Administration tree, select Audit Log
Settings.
2. Click Set Up Syslog Server.
3. Select the desired Transfer Protocol.
4. Enable or disable the Primary Server.
5. Enable or disable the Secondary Server.
6. Enable or disable the Output Detailed Information.
7. Click Apply to save the settings or Cancel to close the window without
saving the settings.
272 Configuring audit logs
System Administrator Guide for VSP Gx00 models and VSP Fx00 models

Hitachi VSP G400 Specifications

General

Brand	Hitachi
Model	VSP G400
Category	Storage
Language	English