3. Click Date and Time.
4. Click Change date and time. The Date and Time Settings window
opens.
5. Set the date and time, then click OK to save the settings and close the
window.
Enabling IPv6 communication
You should assign the SVP the same type of IP addresses (IPv4 or IPv6) that
are used on the storage system. You must also configure the client
computers with the same IP version that you assign to the SVP. In addition,
use the same communication options for both the management client and the
SVP.
If you use IPv6 to display the Device Manager - Storage Navigator main
window when both IPv4 and IPv6 are available, IPv6 addresses are displayed
in the Device Manager - Storage Navigator secondary window but IPv4
communication is actually used.
The following topics provide brief instructions on configuring IPv6
communication.
Note: If the SVP uses IPv6, you must configure management clients to use
IPv6 for communication. Consult your operating system's documentation for
instructions.
Changing network communication settings
This procedure explains how to configure a management client to use IPv6
for communication with an SVP.
Procedure
1. In the maintenance utility, click Administration to expand the
Administration navigation pane.
2. Click Network Settings.
The Network Settings window displays the current network settings
and permissions.
3. In the Network Settings window, click Set Up Network Settings.
The Network Settings dialog box displays the current settings for the
Mac address, IPv4 and IPv6 settings, and the network connection mode
for both controllers 1 and 2. It also displays the current settings for the
maintenance port and the storage system internal network.
4. Change the settings as needed and click Apply.
The dialog box closes and returns you to the Network Settings window.
Changing network permissions
This procedure explains how to block or allow HTTP blocking.
122 Configuring the storage system
System Administrator Guide for VSP Gx00 models and VSP Fx00 models