Note: After adding a license key, if a reboot is required in order to
start a service/protocol or enable a feature, you are instructed to
reboot or restart the system.
For a file license, you can either enter the key manually or import it from
a file. For a block license, you can only import the key from a file:
• To enter the key manually, type it in the field, then click add.
• To import the key, click Choose File / Browse, navigate to the file,
select the key file, then click Import.
After all the keys have been entered or imported, they will be displayed
on the License Keys page. Follow the instructions to reboot the system
(if necessary).
Installing block licenses using maintenance utility
Before you begin
You must have the Storage Administrator (Initial Configuration) role to
perform this task.
Note: If you do not install the prerequisite software before you install the
license key software, the software will install correctly but will be disabled. To
enable a license key, install the prerequisite software, and then enable the
key.
Procedure
1. In the maintenance utility Administration tree, select Licenses.
2. Select whether to enter a key code or specify a license key file.
• Key Code: Enter a key code to install the software. In Key Code,
enter the license key code for the software.
• File: Specify a license key file to install the software. Click Browse
and specify the license key file. You can use a file name of up to 200
alphanumeric characters excluding these symbols: (“ \ : ; , * ? < >
| / ). Include the .plk file extension.
3. Click Apply.
Enabling a license
You can enable a license that is in disabled status.
Before you begin
You must have the Storage Administrator (Initial Configuration) role to
perform this task.
266 Managing license keys
System Administrator Guide for VSP Gx00 models and VSP Fx00 models
To Next Page
Loading...
Need help?
General