Procedure
1. From the Maintenance Utility menu, click License Keys to open the
License Keys window.
2. Select the license to enable. You can select from one to all of the licenses
listed in the window at the same time.
3. Click Enable to display the License Keys window.
4. Check the settings and click Apply.
Disabling a license
You can disable a license that is in enabled status.
Before you begin
You must have the Storage Administrator (Initial Configuration) role to
perform this task.
Procedure
1. From the Maintenance Utility menu, click License Keys to open the
License Keys window.
2. Select the license to disable. You can select from one to all of the
licenses listed in window the at the same time.
3. Click Disable to display the License Keys window.
4. Click Finish.
5. Check the settings and click Apply.
Removing a software license
You can remove a software license that is in disabled status.
Before you begin
You must have the Storage Administrator (Initial Configuration) role to
perform this task.
Procedure
1. In the maintenance utility Administration tree, click License Keys.
2. In the License Keys window, select the license to uninstall. You can
select from one to all of the licenses listed in the window at the same
time.
3. In the License Keys window, click Uninstall Licenses.
4. Check the settings and click Apply.
On rare occasions, a software option that is listed as Not Installed but
still has available licensed capacity (shown as XX TB) might remain in the
list. In this case, select that option and uninstall the software.
Managing license keys 267
System Administrator Guide for VSP Gx00 models and VSP Fx00 models
To Next Page
Loading...
Need help?
General