EasyManuals Logo

Hitachi VSP G400 System Administration Guide

Hitachi VSP G400
414 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #220 background imageLoading...
Page #220 background image
• Certificates for RMI communication are updated asynchronously. The
process takes about two minutes.
• If the service processor certificate is updated while Hitachi Command Suite
is being set up, the setup operation will fail.
• Updating the SSL certificate might change the system drastically and may
lead to service processor failure. Therefore take sufficient care to consider
the content of the certificate and private key to be set.
• After the certificate update is complete, depending on the environment,
the service processor can take 30 to 60 minutes to restart.
Returning the certificate to default
You can return the certificate that was updated by the procedure in
Updating
a signed certificate on page 219 back to default.
Before you begin
• You must have the Storage Administrator (Initial Configuration) role to
perform this task.
• You must be logged into the SVP.
• A private key (.key file) has been created. Make sure that the file name is
server.key. See
Creating a private key on page 215.
• The passphrase for the private key (server.key file) is released.
• A signed public key certificate (.crt file) has been acquired. Make sure that
the file name is server.crt. See
Creating a public key on page 215.
• The private key (.key file) must be in PEM format. You cannot use DER
format.
• The signed public key certificate (.crt file) must be in X509 PEM format.
You cannot use X509 DER format. See
Obtaining a self-signed certificate
on page 217.
• The passphrase for the private key (server.key file) must be released.
Procedure
1. Close all Device Manager - Storage Navigator sessions on the SVP.
2. Open a command prompt window with administrator permissions.
3. In the folder where the .bat file is located, execute the following
command:
C:\MAPP\wk\Supervisor\MappIniSet>MappApacheCrtInit.bat
4. A completion message box displays. Press any key to acknowledge the
message and close the message box.
5. Close the command prompt window.
220 Setting up security
System Administrator Guide for VSP Gx00 models and VSP Fx00 models

Table of Contents

Other manuals for Hitachi VSP G400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hitachi VSP G400 and is the answer not in the manual?

Hitachi VSP G400 Specifications

General IconGeneral
BrandHitachi
ModelVSP G400
CategoryStorage
LanguageEnglish

Related product manuals