EasyManuals Logo

Hitachi VSP G400 System Administration Guide

Hitachi VSP G400
414 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #246 background imageLoading...
Page #246 background image
Viewing alert notifications
You can view alert email messages, alert Syslog messages, and alert SNMP
trap messages in the Device Manager - Storage Navigator Alerts tab and the
Alert Detail window.
Before you begin
You must have the Storage Administrator (View Only) or Storage
Administrator (Initial Configuration) role to perform this task.
• Email: Check your email to view alerts sent by email. Alerts that are
reported through email are the same as the SIM information that is
displayed in the Alert window or reported through an SNMP trap.
• Syslog: Check the messages on the Syslog server to view alert information
sent there.
• SNMP traps: To view SNMP trap information, use the SNMP Manager in
Device Manager - Storage Navigator. See the Hitachi SNMP Agent User
Guide for information about using SNMP traps.
Configuring alert notifications
Procedure
1. In the maintenance utility, click the SNMP tab to display it.
2. In SNMP Agent, click Enable to use the agent or Disable not to use it.
3. Select the Email tab. The Email window displays the current settings for
the Mail Server, SMTP Authentication, an Email Address.
4. To send a test email message, click Send Test Email. A completion
notice displays.
5. Click OK to acknowledge the notice and close the message.
6. Click the Syslog tab. The Syslog window displays the current settings
for the Primary Server, IP address, and port number, and for the
secondary server IP address and port number.
7. To send a test message to the Syslog server, click Send Test message
to the Syslog Server. A completion notice displays.
8. Click OK to acknowledge the notice and close the message.
9. Click the SNMP tab. The SNMP window displays the current settings for
the Storage System Name, Contact, Location, SNMP Trap and SNMP
Manager.
10. To send a test SNMP trap, click Send Test SNMP Trap. A completion
notice displays.
11. Click OK to acknowledge the notice and close the message.
246 Alert notifications
System Administrator Guide for VSP Gx00 models and VSP Fx00 models

Table of Contents

Other manuals for Hitachi VSP G400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hitachi VSP G400 and is the answer not in the manual?

Hitachi VSP G400 Specifications

General IconGeneral
BrandHitachi
ModelVSP G400
CategoryStorage
LanguageEnglish

Related product manuals