The SMU can be configured to control the hosts that can access the SMU and
auxiliary devices managed by the SMU.
Note: If you have a standby SMU, it may take up to 5 minutes after a
configuration change to be synchronized with the active SMU
Procedure
1. Navigate to Home > SMU Administration > Security Options.
Field/Item
Description
Web Application
Security Settings
This section allows you to change web application security settings.
Note: Making any change in this section results in the
application being restarted immediately.
Enable HTTPS
Protocols
By default, all HTTPS protocols are enabled, and the boxes next to the
protocols are checked. Uncheck the check box next to a protocol to
change its state to disabled. Leave at least one protocol enabled that
your browser supports.
Enabled Cipher
Suites
By default, all cipher suites are enabled and are shown in the Enabled
Cipher Suites list box.
Disabled Cipher
Suites
To disable cipher suites, use the arrow to move selected cipher suites to
the Disabled Cipher Suites list box. Leave at least one cipher suite
enabled that your browser supports.
apply Click apply to save your changes.
2. Optionally, to disable cipher suites, use the arrow to move enabled cipher
suites from the Enabled Cipher Suites list at the left to the Disabled
Cipher Suites list at the right. It is necessary to have at least one cipher
suite remain enabled.
242 Setting up security
System Administrator Guide for VSP Gx00 models and VSP Fx00 models
To Next Page
Loading...
Need help?
General