3. Move the current directory to the folder where the tool is available. (For
example: <SVP-root-directory>\DKC200\mp\pc).
4. Specify the output destination of the dump file and execute
Dump_Detail.bat or Dump_Normal.bat.
For example, if you are storing the result of Dump_Detail.bat to C:
\Result_832000400001, enter the following:
C:\MAPP\wk\832000400001\DKC200\mp\pc>Dump_Detail.bat C:
\Result_832000400001
Note:
• A space is required between Dump_Detail.bat and C:\Result.
• The dump file name is hdcp.tgz. To manage dump files by
storage systems, we recommend adding a serial number to the
output folder name. For example, if the serial number is
832000400001, the folder name should be C:
\Result_832000400001.
• When the tool is being executed, is displayed in the command
prompt. When the execution is completed, is displayed.
"Executing..."
"zSv_AutoDump.exe is completed."
5. A completion message box displays. Press any key to acknowledge the
message and close the message box.
hdcp.tgz: This is the dump file. Give this file to the maintenance
personnel. If you save too many dump files in the SVP storage, space
might not be available. Therefore, move the dump file outside of SVP
storage.
zSv_AutoDump.log: This is the log file of the dump tool. If the dump file
is not output, give this log file to the maintenance personnel. If the dump
file is output, delete the log file.
6. Close the Windows command prompt.
Managing storage system reports 279
System Administrator Guide for VSP Gx00 models and VSP Fx00 models
To Next Page
Loading...
Need help?
General