Holder C270 - Speeds for working

Operation C250 ... C370
Translation of Original Operating Manual 156319-04 105
Speeds for working
C270_060a
B
B
A
C
C270_077a
A
C
B
B
Programmes 3 and 4 for working operation
The vehicle is stationary.
1. Set the
fine adjustment wheel (C) to 0.
2. Set the programme switch (A) to position 3 or
4.
3. Switch on the PTO shaft if needed.
4. Adjust the PTO shaft speed with the fine ad-
justment control (B).
ADVICE
When you are driving in programmes
3 or 4, the driving speed can be con-
trolled independently of the engine
speed and the PTO shaft speed. The
engine speed must reach at least 1500
rpm because the vehicle can only be
put into operation above this speed.
In drive programme position 3 or 4, the speed pre-
set on the fine adjustment wheel (C) is controlled
by the power requirement. That implies, for exam-
ple, that the driving speed becomes slower if an
attachment requires more power. If the power re-
quirement for the attachment decreases, the vehi-
cle accelerates back to the previously set speed.