Holder C270 - Important instructions for the operation of the volume dividers I, II and the implement pump*

Attachments C250 ... C370
Translation of Original Operating Manual 156319-04 187
Important instructions for the operation of
the volume dividers I, II and the implement
pump*
ADVICE
If a hydraulic rear PTO shaft is installed
in the vehicle and connected or in op-
eration, the volume divider II and the
implement pump are no longer avail-
able for other functions.
ADVICE
Use the volume dividers I, II and the
implement pump only as long as nec-
essary.
ADVICE
Switch off the volume dividers I/II
and implement pump immediately af-
ter use so that the hydraulic oil does
not heat up unnecessarily.
ADVICE
The maximum pressure (set pressure)
of the implement servopump is 250
bar. Attachments must be matched to
this.
ADVICE
The hydraulic system is damaged by
excessive heating of the hydraulic oil.
ADVICE
Avoid unnecessary oil heating by
matching the available quantity of oil
to the load (attachment).
ADVICE
Do not leave the volume divider or the
implement pump switched on under
any circumstances
•
When the engine is running and no
load is connected to the couplings
•
When no load is operating
•
When driving without oil consump-
tion
* Optional equipment