Holder C270 - Stationary mode operation

Special operation C250 ... C370
138 Translation of Original Operating Manual 156319-04
Stationary mode operation
C270_069
1
In stationary mode, the vehicle can be used
for powering a variety of equipment (e.g. water
pumps, wood splitters, etc.) via the PTO shaft (1).
ADVICE
Position the vehicle horizontally in
both directions
1. Couple the stationary device with a suitable
cardan shaft to the front or rear PTO shaft.
2. Set drive programme switch to 0.
3. Set the parking brake and further secure the
vehicle with wedges.
DANGER
Danger of accident
•
Before switching on the PTO shaft,
take care that no one is present in
the danger zone of the vehicle and
the rotating PTO shaft
4. Switch on the PTO shaft and adjust the at-
tachment to the necessary rotational speed.