Attachments C250 ... C370
Translation of Original Operating Manual 156319-04 189
1. Connect the hydraulic hoses and the leakage
oil line of the attachment to the correspond-
ing plug-in couplings for the drive (A or C)
and return (B or D) at the front end, rear end
on the vehicle.
ADVICE
Switch the key (1 or 2) only at a low
engine speed.
2. Turn the volume adjustment (1a, 2a) all the
way to the left.
3. Unlock the catch on the safety switch (1, 2)
and press the switch downwards. Indicator
lamp lights up. The attachment is supplied
with oil.
4. Increase the engine speed to the desired ro-
tational speed (see multifunction display).
5. Increase the working speed of the attachment
to the desired value by turning the volume
adjustment (1a, 2a) to the right.
6. Press the safety switch upwards to switch off
the drive. Oil supply is switched off. Indicator
lamp goes out.
ADVICE
Engine stopped without previously
switching off volume divider II? See
page 190.
ADVICE
If less than 40 l/min oil is required at
volume divider II, the engine speed
can be reduced or volume divider I
can be used. This avoids unnecessary
heating of the oil.
* Optional equipment
To Next Page
Loading...
