To filter the alarm table to show only alarms on specific assets (or alarm groups)
1. Click the name of the asset (or alarm group) in the Alarm Tracker pane.
This filters the alarm table to show only alarms in the selected asset (or alarm group).
2. To filter the alarm table to show alarms on multiple assets, hold down the CTRL key
while clicking the asset names.
3. To undo the asset filter, click the asset name (or alarm group) again.
The alarm table now shows an unfiltered view of all alarms.
To call up a Point Detail or Associated display
1. Click the alarm icon whose display you want to view.
This selects the alarm cluster to which this alarm belongs and filters the alarm table
below the Alarm Tracker pane to show only alarms in the selected cluster.
2. In the alarm table, right-click the alarm whose details you want to view and choose
Detail Display or Associated Display on the shortcut menu.
Tip:
You can use the same procedure to call up the Suppression Status display.
To change the height of the Alarm Tracker pane and the alarm tracks
1. Click the line dividing the Alarm Tracker pane from the alarm table pane.
The mouse pointer changes to indicate that the pane can now be re-sized horizontally
and a thick, dark line appears between the two panes.
2. Drag the thick, dark line down (or up) to increase (or decrease) the height of the Alarm
Tracker pane.
The height of each alarm track is increased (or decreased) proportionately. Note that
you cannot directly control the height of individual alarm tracks: the height of each
track (relative to other tracks) is defined when the alarm tracker is configured.
Attention:
Responding to alarms
Honeywell 2017 129
To Next Page
Loading...
Need help?
General
