Honeywell Experion LX User Manual

n
Nothing is selected if the MODE is not AUTO or MAN.
The system auto selects when you change the MODE using the keyboard, menu/toolbar
command, or you directly change the MODE element on the faceplate.
This behavior applies to most faceplates that have a MODE, SP, and OP element. Not all
faceplates have these elements and this auto-selection behavior may not apply. In addition,
some faceplates have elements that are considered more appropriate for auto-selection. The
auto-selection behavior of these faceplates may be customized to the requirements of your site
and operations.
Selection independent commands
You can always perform the following commands on the faceplate's current point, as long as
the faceplate has focus:
Command OEP/IKB keyboard PC keyboard
Select SP SP key Alt+11
Select OP OUT key Alt+12
Change mode to Manual MAN key Alt+F5
Change mode to Auto AUTO key Alt+F6
Change mode to Normal NORM key Alt+F7
Acknowledge alarm ACK key F4
Silence SIL key
Point Detail DETAIL key F12
Group Display GROUP key F6
Trend Display TREND key F7
Associated Page ASSOC DISP key F2
Enable/Disable LOAD key F11
This behavior does not vary based on the auto-selection configuration.
Selection dependent commands
The following commands require an element in the faceplate to be selected:
Command OEP/IKB keyboard PC keyboard
Raise RAISE key F9
Using faceplates
Honeywell 2017 64

Honeywell Experion LX Specifications

General

Brand	Honeywell
Model	Experion LX
Category	Control Systems
Language	English