Pan and Zoom display thumbnail and viewport indicator
Within Pan and Zoom displays, only data bound display elements within the current viewport
are subscribed to data so as to reduce load on the system. When the viewport changes, display
elements that are no longer in view are automatically unsubscribed, while those that come into
view are automatically subscribed.
You can update the viewport in the main display by dragging the viewport indicator in the
thumbnail, or by dragging the display itself. This is referred to as Panning. Panning enables
you to move quickly to something that was previously not in view, or only partially in view.
To pan within a pan and zoom display
1. Click the mouse button on any blank space within the display.
The cursor changes to a hand to indicate that the display can be moved.
2. While still holding down the primary mouse button, drag the display until you can see
the desired location.
The content shown in the thumbnail updates at the same time to match that shown
Using displays
Honeywell 2017 50
To Next Page
Loading...
Need help?
General
