Honeywell FlexLine SmartServo 954 User Manual

COMMISSIONING
94 Service Manual Part No.: 4417340 Revision 1
954 SmartServo FlexLine
Name Value Range Default Value Explanation
[SAT frequency limit] <120>
Determines the
maximum frequency
change when the
displacer has been
raised.
[SAT intended interface] <Interface 1>
<Interface 2>
<Interface 3>
<Interface 1>
Determines at/around
which interface the SAT
is performed.
[SAT invalidate level] <enable>
<disable>
<disable>
Determines if the actual
interface will go the
health BAD during the
SAT.
[SAT level last fail] 999.9999
Shows the level at
which the last SAT
failed.
[SAT level last executed]
Shows the interface
level at the moment the
SAT was performed.
[SAT minimum level
executed]
Shows the minimum
interface level where
the SAT was
performed.
[SAT maximum level
executed]
Shows the maximum
interface level where
the SAT was
performed.
[SAT highest number of
retries]
Shows the number of
retries in case a SAT
performance failed.
[SAT number of
executed tests]
Shows the number of
SAT’s performed since
the gauge was
powered up.
[SAT status]
Shows the result of the
last performed SAT.
[SAT time elapsed since
last SAT]
Shows the elapsed
time since the previous
SAT
[SAT RTC last fail]
Shows the date of the
RTC when there was a
SAT fail.

Honeywell FlexLine SmartServo 954 Specifications

General

Brand	Honeywell
Model	FlexLine SmartServo 954
Category	Measuring Instruments
Language	English