Honeywell FlexLine SmartServo 954 User Manual

COMMISSIONING
66 Service Manual Part No.: 4417340 Revision 1
954 SmartServo FlexLine
7.3.4.2 Board specific
Name Value Range Default Value Explanation
[Date and time]
Shows the date and
time of the RTC chip.
[Write date and time] <2018,1,1,0,0,0>
Here you write the
actual date and time
you want to set.
[Set date and time]
This command sets
the new entered date
and time to the RTC.
[Run hours] Shows the amount of
hours the servo
continuously has run.
[Magnet
temperature]
Shows the magnet
temperature with a
status whether it is
valid or not.
[Voltage CPU core]
Shows the measured
voltage of the CPU
core.
[Board W&M
intended]
<enable>
<disable>
<disable>
This board can be
W&M sealed.
Therefor the user
needs to set this
board as W&M
intended.
[W&M unseal step 1]
This command can be
given if the user
wants to remove the
(electronic) W&M
seal.
It is done in 2 steps.
This is step 1.
Next entity is step 2.
[W&M unseal step 2]
This command is step
2 of the remove W&M
seal procedure. After
this command the
seal is removed.

Honeywell FlexLine SmartServo 954 Specifications

General

Brand	Honeywell
Model	FlexLine SmartServo 954
Category	Measuring Instruments
Language	English