COMMISSIONING
244 Service Manual Part No.: 4417340 Revision 1
954 SmartServo FlexLine
The total tank shell deformation then becomes:
δh
21.945
= 0.19 + 0.45 + 0.72 + 0.75 + 0.76 + 0.77 + 0.78 + 0.72 +
0.90
= 6.04 mm.
The above calculation is for a full tank (level 21.945 m). The tank shell
deformation for the same tank, but then with a level of 21 metres is:
Likewise, the other ring deformations are to be calculated. If that is
done the outcome is:
δh
21.000
= 0.07 + 0.33 + 0.61 + 0.67 + 0.70 + 0.72 + 0.73 + 0.68 +
0.85
= 5.36 mm
Figure 7-42 Example steel storage tank with diameter of 83.82 m
To Next Page
Loading...
