SAFETY AND SECURITY
Part No.: 4417340 Revision 1 Service Manual 11
954 SmartServo FlexLine
Security note 4
After commissioning the 954 SmartServo FlexLine enclosure should be
physically sealed.
By having the physical seals applied the boards are not directly
accessible to remove the hardware configuration protection jumpers.
In case the physical seals are removed tamper is detected by visual
inspection which will be interpreted as fraud from a legal perspective.
How to report a security vulnerability
For the purpose of submission, a security vulnerability is defined as a
software defect or weakness that can be exploited to reduce the
operational or security capabilities of the software or device.
Honeywell investigates all reports of security vulnerabilities affecting
Honeywell products and services.
To report potential security vulnerability against any Honeywell product,
please follow the instructions at:
https://honeywell.com/pages/vulnerabilityreporting.aspx
Submit the requested information to Honeywell using one of the
following methods:
Send an email to security@honeywell.com.
or
Contact your local Honeywell Process Solutions Customer Contact
Centre (CCC) or Honeywell Technical Assistance Centre (TAC) listed in
the “Support and Contact information” section of this document.
To Next Page
Loading...
