Honeywell FlexLine SmartServo 954 - Operational Commands

COMMISSIONING
Part No.: 4417340 Revision 1 Service Manual 75
954 SmartServo FlexLine
7.3.4.9 Operational commands
Name Value Range Default Value Explanation
[Host command mode] <Enable>
<Disable>
All <Enable>
With this entity the user
can enable or disable
the following
commands:
-Interface 1
-Interface 2
-Interface 3
-Block
-Calibrate
-Dip mode
-Freeze
-Interface profile
-Lock test
-Test gauge
-Tank profile
-Unlock
-Density water dip
-Water density dip
-Test
-Lock to level
-Lock test to level
[Freeze]
This command stops
the motor. This
situation will be
maintained until a
[Unlock] command is
given.
[Test gauge]
This command will rise
the displacer 6 cm. up
and after that the
interface is searched
again. (reproduction
test)