TROUBLE SHOOTING
Part No.: 4417340 Revision 1 Service Manual 285
954 SmartServo FlexLine
Informational status codes
Numbers in the range 6336-6911 are informational status codes.
Informational codes have a lower priority than warning or error codes,
so if a warning or error is active the informational status isn’t visible.
Status code
(SmartView)
Description
(Engauge)
Remarks
6346 Lock to level command active
6347 Lock test to level command active
6348 Test command active
6349 Density water dip command active
6350 Water density dip command active
6351 Check bearings command active
6352 Go up command active
6353 Test gauge command active
6354 Tank profile command active
6355 Measure frequency command active
6356 Interface profile command active
6358 Go down command active
6359 Calibrate command active
6361 Lock test command active
6362 Interface 1 command active
6363 Interface 2 command active
6364 Interface 3 command active
6365 Block command active
6366 Freeze command active
6367 Dip mode command active
6368 Balance test command active
6369 Run down command active
6370 Maintenance mode active
6371 Motor limit high exceeded
6372 Motor limit low exceeded
6373 Firmware update busy
6398 Motor limit reached
To Next Page
Loading...
Need help?
General
