Honeywell FlexLine SmartServo 954 - HCM-GPU Board Specific; Baud Rate; Turn Around Delay

COMMISSIONING
Part No.: 4417340 Revision 1 Service Manual 167
954 SmartServo FlexLine
Reset device button: All modules of the SmartLink are reset
Reset board button: Only the HCM-GPU module is reset
Software version: Current installed software version for the HCM-GPU
module.
The TAB sheet Board Specific provides host communication
information as baud rate and turn around delay time (Refer to Figure
"HCM-GPU Board Specific").
Figure 7-29 HCM-GPU Board Specific
Baud rate
Host communication baud rate of the SmartLink. The default setting is
38400. When required, the baud rate can be changed. The following
settings are possible:
 115200
 57600
 38400
 19200
 9600
 4800
 2400
 1200
To make the change effective, press the Send button. When the baud
rate is changed, also change the baud rate at the COM port icon (two
levels higher).
Turn around delay