Honeywell FlexLine SmartServo 954 - Some Important Settings

COMMISSIONING
Part No.: 4417340 Revision 1 Service Manual 137
954 SmartServo FlexLine
7.3.8.2 Some Important Settings
The FII-RTD can be tailored to the need of the customer by a lot of
settings. See section 7 Commissioning
Some important settings of the FII-RTD in Board Specific tab are listed
below.
Setting Remarks
[Measurement type]
″ MPT
″ MRT
″ Mtt
″ No measurement type
″ RTD 3-wire
″ RTD 4-wire
[Element type]
″ Cu100
″ Cu90 Beacon
″ Cu90 Enraf
″ Cu90 Nulectrohms
″ Ni191
″ No element type
″ Pt100 large
″ Pt100 small
″ PtCu100
″ Sangamo MRT
″ Sangamo spot
″ Thermocouple
[RTD configuration]
• RTD1 in tank
• RTD1 + RTD2 in tank
• RTD1 in tank + RTD2 ambient
• RTD1 ambient
″ No RTD configuration
″ RTD1 in tank
″ RTD1 in tank + RTD2 ambient
[Gauge temperature scale]
Can be:
• IPTS-68
• ITS-90
[Lowest element offset]
This is the distance from tank bottom till lowest element
position
[Number of elements]
Can be 1..6
[MPT sensor length]
-