Honeywell FlexLine SmartServo 954 User Manual

COMMISSIONING
Part No.: 4417340 Revision 1 Service Manual 85
954 SmartServo FlexLine
7.3.4.14 Compensation
Name Value Range Default Value Explanation
[Setpoint compensation] <enable>
<disable>
<enable>
<disable>
<disable>
Enable or disable the
following
compensations for the
set point:
-Wire weight
Compensates for the
wire weight
-Unbalance
Compensates for the
unbalance of the drum
and bearings
-Density
Compensates for the
change in density over
time
[Compensation wire
weight]
Shows the wire weight
compensation.
[Compensation
unbalance]
Shows the unbalance
compensation.
[Compensation density]
Shows the density
compensation.
[Level compensation] <enable>
<disable>
<enable>
<enable>
<disable>
<disable>
<disable>
<disable>
<disable>
<disable>
Enable or disable the
following
compensations for the
level:
-Magnet coupling
Compensates level for
the slip in the magnet
coupling caused by
different weights
-Magnet coupling
temperature
Compensates level for
the slip in the magnet
coupling caused by
temperature
Note: Only applied
when Magnet coupling
compensation also is
enabled.
Note: Both magnet
couplings should be
(default) enabled

Honeywell FlexLine SmartServo 954 Specifications

General

Brand	Honeywell
Model	FlexLine SmartServo 954
Category	Measuring Instruments
Language	English