COMMISSIONING
Part No.: 4417340 Revision 1 Service Manual 143
954 SmartServo FlexLine
7.3.8.4.4 Commissioning Parameters for All Types of Probes
Engauge *Product temperature* Tab
☛ The following entities can be set set by Engauge or HART
SmartView for a specific functioning of the FII-RTD module in an
instrument. The default values are available after initialization of the
non-volatile memory; so check each entity for its correctness.
Name Explanation Value Range Default
[Product immersion depth]
The minimum required
product level distance
above an element before
this element is taken into
account in the average
product temperature
calculation
floating point number:
<-x.x .. +x.x>
<0.5>
[Hysteresis]
This is a hysteresis
mechanism distance
around the switching points
of the elements that are
taken into account in the
calculation.
floating point number:
<-x.x .. +x.x>
<0.1>
[High high alarm]
[High alarm]
[Low alarm]
[Low low alarm]
4 thresholds for activating a
related alarm status in the
Primary Value
floating point numbers:
<-x.x .. +x.x>
<1.0E22>
[Alarm test enable]
Enables (if activated, see
next listed entity) the
simulation of one of the 4
alarms for a minute, by
simulating the actual
measured Primary Value is
slightly below or above the
alarm threshold.
<Enable>
<Disable>
<disable>
[Alarm test]
Activates and selects at the
same time the Alarm test (if
enabled with the [Alarm test
enable] listed before, and the
4 alarm thresholds are
properly set).
<No Alarm>
<High-high alarm>
<High alarm>
<Low alarm>
<Low-low alarm>
<No Alarm>
[Function identification] The current module’s
function name. This
function is visible on the
HART SmartView
13 characters
<Product temp.>
[Element offset]
Each element can
individually be given an
offset.
floating point numbers:
<-x.x .. +x.x>
<0.0>
To Next Page
Loading...
Need help?
General
