SERVICE TOOLS
44 Service Manual Part No.: 4417340 Revision 1
954 SmartServo FlexLine
On selection of an available entity, the [value edit] screen is
presented (see Figure 5-15).
o If an invalid value is entered, the message “value out of
range” is displayed.
o If the value is not accepted by the FlexConn module, the
message “value not accepted” is displayed.
o You can scroll along the characters by push and hold
the up button.
o An entity modification is only executed on simultaneously
pressing the left + right button. After this, first a range check
is performed. If the modification is accepted, you return to
the [value edit] screen.
o The cursor can be shifted to the right by pressing the right
button.
o You can return to the [entity list] screen by pressing the left
button.
NOTE: Use the left button to return to the [entity list] screen without
executing the modification(s). Press the left + right button
simultaneously to undo this (these)
modification(s)!
Figure 5-15 The entity list screen
To Next Page
Loading...
