Honeywell FlexLine SmartServo 954 - Page 85

COMMISSIONING
Part No.: 4417340 Revision 1 Service Manual 77
954 SmartServo FlexLine
Name Value Range Default Value Explanation
[Lock test stop level] <0.0>
Determines the level to which
the displacer goes after a
Lock to level, Lock test to
level or Test command.
[Lock to level]
This command sends the
displacer to the [Lock test
stop level] and remains
there.
[Lock test to level]
This command sends the
displacer to the [Lock test
stop level] and when
reached, issues an Unlock
command and the displacer
returns to the selected
interface.
[Test]
This command sends the
displacer to the [Lock test
stop level] and when
reached, issues a Block
command and after some
time issues an Unlock
command and the displacer
returns to the selected
interface.
[Water interface dip]
This command searches for
the water level and after that
returns to the default
operation mode.
[CIU water interface
dip]
This command searches for
the water level and stays
there.