HP 1920 Gigabit Ethernet Switch Series User Manual

125
Figure 117 Configuring an SNMP read-only community
3. Configure a read and write community:
a. Click Add on the Community tab page.
The Add SNMP Community page appears.
b. Enter private in the Community Name field, and select Read and write from the Access Right
list.
c. Click Apply.
Figure 118 Configuring an SNMP read and write community
4. Enable SNMP traps:
a. Click the Trap tab.
The Trap tab page appears.
b. Select Enable SNMP Trap.
c. Click Apply.

HP 1920 Gigabit Ethernet Switch Series Specifications

General

Brand	HP
Model	1920 Gigabit Ethernet Switch Series
Category	Switch
Language	English