EasyManuals Logo

HP 1920 Gigabit Ethernet Switch Series User Manual

HP 1920 Gigabit Ethernet Switch Series
547 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #422 background imageLoading...
Page #422 background image
409
• Configure all users to belong to the domain aabbcc.net, and specify local authentication for users
in the domain.
• Use the MAC address of each user as the username and password for authentication, and require
that the MAC addresses is hyphenated and in lower case.
• Configure the access device to detect whether a user has gone offline every 180 seconds. When a
user fails authentication, the device does not authenticate the user within 180 seconds.
Figure 390 Network diagram
Configuring a local user
# Add a local user. Set the username and password as 00-e0-fc-12-34-56, the MAC address of the user.
Set the service type to LAN access. (Details not shown.)
Configuring AAA
1. From the navigation tree, select Authentication > AAA.
2. On the Domain Setup page, enter the domain name aabbcc.net and click Apply.
Figure 391 Creating an ISP domain
3. Click the Authentication tab.
4. Select the ISP domain aabbcc.net.
5. Select LAN-access AuthN, and select Local from the list.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP 1920 Gigabit Ethernet Switch Series and is the answer not in the manual?

HP 1920 Gigabit Ethernet Switch Series Specifications

General IconGeneral
BrandHP
Model1920 Gigabit Ethernet Switch Series
CategorySwitch
LanguageEnglish

Related product manuals