5-12
Hardkey and Softkey Reference
AM
Bus
This softkey is one of the choices in the AM Sweep Trigger menu. With Bus
selected, you use the HP-IB to trigger single sweeps of swept-sine amplitude
modulation.
Softkey Location: Press
AM, AM Waveform, Swept-Sine, AM Sweep Trigger, Bus
Status after Normal Preset: AM sweep trigger is set to Immediate
SCPI Commands:
[:SOURce]:AM[1]|2:INTernal[1]:SWEep:TRIGger BUS
[:SOURce]:AM[1]|2:INTernal[1]:SWEep:TRIGger?
Dual-Sine
Pressing this softkey reveals a menu of choices for setting the dual-sine amplitude
modulation parameters. In this menu you can set the AM rates for two separate
tones. In addition, you can set the AM depth for
AM Path 1 and AM Path 2 and also
set a ratio of the tone 2 AM depth to the tone 1 AM depth.
Softkey Location: Press
AM, AM Waveform, Dual-Sine
SCPI Commands:
[:SOURce]:AM[1]|2:INTernal[1]:FUNCtion:SHAPe DUALsine
[:SOURce]:AM[1]|2:INTernal[1]:FUNCtion:SHAPe?
Ext
This softkey is one of the choices in the AM Sweep Trigger menu. Choosing Ext
allows you to trigger swept-sine amplitude modulation using the signal applied to
the TRIGGER IN rear panel connector. Set the polarity of the trigger signal using
the
Trigger In Polarity Neg Pos softkey.
Softkey Location: Press
AM, AM Waveform, Swept-Sine, AM Sweep Trigger, Ext
Status after Normal Preset: AM sweep trigger is set to Immediate
SCPI Commands:
[:SOURce]:AM[1]|2:INTernal[1]:SWEep:TRIGger EXTernal
[:SOURce]:AM[1]|2:INTernal[1]:SWEep:TRIGger?