HP ESG Series - Φ M Sweep Trigger; Φ M Tone 1 Rate

5-104
Hardkey and Softkey Reference
Phase Modulation
ΦM Sweep Trigger
Pressing this softkey reveals a menu of choices for triggering swept-sine phase
modulation. You can choose triggering that occurs immediately, triggering that is
supplied by the HP-IB, triggering on either the positive or negative edge of a
signal supplied to the TRIGGER IN connector, or triggering by the front panel
Trigger key.
Softkey Location: Press
FM/ΦM hardkey, toggle FM/ΦM softkey to ΦM, press
More (1 of 2), ΦM Waveform, Swept-Sine, ΦMSweepTrigger
Status after Normal Preset: Immediate
SCPI Commands:
:TRIGger[:SEQuence]:SOURce?
Φ
M Tone 1 Rate
Press this softkey to set the internal modulation frequency for the ΦM tone 1.
Enter the desired rate using the up and down arrow keys, the front panel knob, or
enter a value using the numeric keypad and press the
kHz or Hz terminator softkey.
The range of values allowed is 0.1 Hz through 50 kHz. The minimum increment
allowed is 0.1 Hz.
This softkey is coupled to the
ΦMRate softkey in the initial ΦM Menu and the
ΦMStartRate softkey in the ΦM Swept-Sine Menu. Any value set for
ΦMTone1Rate is reflected in the ΦMRate and ΦMStartRate softkeys.
Conversely, if you change the value for either the
ΦM Rate softkey or the
ΦMStartRate softkey, the value for ΦMTone1Rate is changed to match.
Softkey Location: Press
FM/ΦM hardkey, toggle FM/ΦM softkey to ΦM, press
More (1 of 2), ΦM Waveform, Dual-Sine, ΦMTone1Rate
Status after Normal Preset: 400.0 Hz
SCPI Commands:
[:SOURce]:PM[1]|2:INTernal[1]:FREQuency <val><unit>
[:SOURce]:PM[1]|2:INTernal[1]:FREQuency?