5-78
Hardkey and Softkey Reference
LF Out
LF Out Tone 2 Ampl % Of Peak
Press this softkey to set the ratio of the peak amplitude of LF Out tone 2 to the
peak amplitude of LF Out as a percent. The range of values allowed is 0 to 100%.
The minimum increment allowed is 0.1%. The sum of the two LF Out amplitudes
results in the total LF Out amplitude (set by the
LF Out Amplitude softkey in the
initial LF Out Menu.
For example, if the total LF Out amplitude is 300 mVp and you set
LF Out Tone 2 Ampl % Of Peak to 33%, then the amplitude of LF Out tone 1 will be
200 mVp and the amplitude of LF Out tone 2 will be 100 mVp (33% of 300 mVp)
so that the amplitude of the two tones adds up to 300 mVp (200 mVp plus
100 mVp).
This softkey is only active when you have selected the internal source to operate
as a function generator.
Softkey Location: Press
LF Out, LF Out Source, Function Generator,
LF Out Waveform, Dual-Sine, LF Out Tone 2 Ampl % Of Peak
SCPI Commands:
[:SOURce]:LFOutput:FUNCtion:FREQuency:ALTernate:AMPLitude:PERCent
<val><unit>
[:SOURce]:LFOutput:FUNCtion:FREQuency:ALTernate:AMPLitude:PERCent?
To Next Page
Loading...
