HP ESG Series - Square; Swept-Sine; Triangle

5-49
Hardkey and Softkey Reference
FM
Square
This softkey lets you specify square as the frequency modulation waveform for
the
FM Path 1 and FM Path 2 configurations. Notice that the selected waveform
applies only to whichever FM path configuration you have currently selected.
Softkey Location: Press
FM/ΦM, More (1 of 2), FM Waveform, Square
SCPI Commands:
[:SOURce]:FM[1]|2:INTernal[1]:FUNCtion:SHAPe SQUare
[:SOURce]:FM[1]|2:INTernal[1]:FUNCtion:SHAPe?
Swept-Sine
Pressing this softkey reveals a menu of choices for setting the swept-sine
frequency modulation parameters. In this menu you can set the start and stop FM
rate and the sweep time. You can set the signal generator to a single,
externally-triggered sweep on either a negative or positive TTL level or you can
choose continuous sweep, triggered immediately. In this menu you can also select
either a positive or negative polarity for the TRIGGER OUT signal.
Softkey Location: Press
FM/ΦM, More (1 of 2), FM Waveform, Swept-Sine
SCPI Commands:
[:SOURce]:FM[1]|2:INTernal[1]:FUNCtion:SHAPe SWEPtsine
[:SOURce]:FM[1]|2:INTernal[1]:FUNCtion:SHAPe?
Triangle
This softkey lets you specify triangle as the frequency modulation waveform for
the
FM Path 1 and FM Path 2 configurations. Notice that the selected waveform
applies only to whichever FM path configuration you have currently selected.
Softkey Location: Press
FM/ΦM, More (1 of 2), FM Waveform, Triangle
SCPI Commands:
[:SOURce]:FM[1]|2:INTernal[1]:FUNCtion:SHAPe TRIangle
[:SOURce]:FM[1]|2:INTernal[1]:FUNCtion:SHAPe?