5-154
Hardkey and Softkey Reference
Sweep/List
Freq Start
Press this softkey to set the frequency of the first point in the sweep. You can set
the value anywhere in the range of the signal generator’s specified output
frequency. Press
Freq Start and frequency becomes the active function for the first
point in the sweep. To enter the value, rotate the front panel knob until the desired
value is displayed, use the up and down arrow keys, or enter the value using the
numeric keypad and press the
GHz, MHz, kHz, or Hz terminator softkey.
Softkey Location: Press
Sweep/List, Configure Step Sweep, Freq Start
Status after Normal Preset: Maximum specified frequency
SCPI Commands:
[:SOURce]:FREQuency:STARt <val><unit>
[:SOURce]:FREQuency:STARt?
Freq Stop
Press this softkey to set the frequency of the last point in the sweep. You can set
the value anywhere in the range of the signal generator’s specified output
frequency. Press
Freq Stop and frequency becomes the active function for the last
point in the sweep. To enter the value, rotate the front panel knob until the desired
value is displayed, use the up and down arrow keys, or enter the value using the
numeric keypad and press the
GHz, MHz, kHz, or Hz terminator softkey.
Softkey Location: Press
Sweep/List, Configure Step Sweep, Freq Stop
Status after Normal Preset: Maximum specified frequency
SCPI Commands:
[:SOURce]:FREQuency:STOP <val><unit>
[:SOURce]:FREQuency:STOP?
Goto Bottom Row
Press this softkey to move the selection bar to the bottom row of list sweep points
in the Goto Row menu that is accessed from the Configure List Sweep menu. If
you are in the Goto Row menu that is accessed from the Load/Store menu, the
selection bar moves to the bottom row of the catalog of list files.
Softkey Location: Press
Sweep/List, Configure List Sweep, Goto Row,
Goto Bottom Row or press Sweep/List, Configure List Sweep, More (1 of 2),
Load/Store
, Goto Row, Goto Bottom Row
To Next Page
Loading...
Need help?
General
