HP ESG Series - Binary; Black Pixels Screen Test; Brightness

5-170
Hardkey and Softkey Reference
Utility
Binary
This softkey lets you specify that only binary files are to be listed on the display
when
Memory Catalog is selected.
Catalog type is a persistent state; it is not changed by an instrument preset or by a
power cycle.
Softkey Location: Press
Utility, Memory Catalog, Catalog Type, Binary
SCPI Commands:
:MEMory:CATalog:BINary?
Black Pixels Screen Test
This softkey is provided for factory use in testing the display. Pressing this softkey
sets all the pixels on the display to black. Pressing the
Local front panel key
returns the display to normal signal generator operation.
Softkey Location: Press
Utility, Display, Black Pixels Screen Test
Brightness
Use this softkey to adjust the display brightness (intensity). The display is set to
maximum brightness at the factory. To change the brightness, press
Utility,
Display, Brightness. The current value shown in the active entry area is a relative
value for brightness. Increasing the number increases the brightness; decreasing
the number decreases the brightness. You can adjust the brightness value to any
number from 1 through 50. (To adjust the brightness via remote operation, set the
value from 0.0 to 1.0.) Use the front panel knob, the up and down arrow keys, or
enter a value using the numeric keypad and press the
Enter terminator softkey.
Brightness is a persistent state; it is not affected by an instrument preset or by a
power cycle.
Softkey Location: Press
Utility, Display, Brightness
SCPI Commands:
:DISPlay:BRIGhtness <value>
:DISPlay:BRIGhtness?