5-139
Hardkey and Softkey Reference
RF On/Off
RF On/Off
This front panel hardkey toggles the RF signal on and off at the RF OUTPUT
connector. Although you can configure and engage various modulations, no signal
is available at the RF OUTPUT connector until
RF On/Off is set to On. An
annunciator is always turned on in the display to indicate whether RF is turned on
or off.
Status after Normal Preset: RF Off
SCPI Commands:
:OUTPut[:STATe] ON|OFF|1|0
:OUTPut[:STATe]?
To Next Page
Loading...
