HP ESG Series - Ampl Stop; Bus

5-149
Hardkey and Softkey Reference
Sweep/List
Ampl Stop
Press this softkey to set the amplitude of the last point in the sweep. You can set
the value anywhere in the range of the signal generator’s specified output power.
Press
Ampl Stop and amplitude becomes the active function for the last point in
the sweep. To enter the value, rotate the front panel knob until the desired value is
displayed, use the up and down arrow keys, or enter the value using the numeric
keypad and press the
dBm, dBuV, dBuVemf, mV, uV, mVemf, or uVemf terminator
softkey.
Softkey Location: Press
Sweep/List, Configure Step Sweep, Ampl Stop
Status after Normal Preset: −135 dBm
SCPI Commands:
[:SOURce]:POWer:STOP <val><unit>
[:SOURce]:POWer:STOP?
Bus
This softkey is one of the choices in both the Sweep Trigger menu and the Point
Trigger menu. Press either the
Sweep Trigger softkey or the Point Trigger softkey
to view these menus. Choosing
Bus in the Sweep Trigger menu allows you to
trigger a list or step sweep using the HP-IB. Choosing
Bus in the Point Trigger
menu allows you to trigger a sweep point-by-point using the HP-IB via *TRG or
the GET line (Group Execute Trigger).
Softkey Location: Press
Sweep/List, More (1 of 2), Sweep Trigger, Bus
or press Sweep/List, More (1 of 2), Point Trigger, Bus
Status after Normal Preset: Sweep and point trigger are set to Immediate
SCPI Commands:
[:SOURce]:LIST:TRIGger:SOURce BUS
[:SOURce]:LIST:TRIGger:SOURce?