HP ESG Series - Φ M Tone 2 Rate; Φ M Waveform

5-105
Hardkey and Softkey Reference
Phase Modulation
ΦM Tone 2 Rate
Press this softkey to set the internal modulation frequency for the ΦM tone 2.
Enter the desired rate using the up and down arrow keys, the front panel knob, or
enter a value using the numeric keypad and press the
kHz or Hz terminator softkey.
The range of values allowed is 0.1 Hz through 50 kHz. The minimum increment
allowed is 0.1 Hz.
This softkey is coupled to the
ΦMStopRate softkey in the ΦM Swept-Sine Menu.
Any value set for
ΦMTone2Rate is reflected in the ΦMStopRate softkey.
Conversely, if you change the value for the
ΦMStopRate softkey, the value for
ΦMTone2Rate is changed to match.
Softkey Location: Press
FM/ΦM hardkey, toggle FM/ΦM softkey to ΦM, press
More (1 of 2), ΦM Waveform, Dual-Sine, ΦMTone2Rate
Status after Normal Preset: 400.0 Hz
SCPI Commands:
[:SOURce]:PM[1]|2:INTernal[1]:FREQuency:ALTernate <val><unit>
[:SOURce]:PM[1]|2:INTernal[1]:FREQuency:ALTernate?
Φ
M Waveform
Pressing this softkey reveals a menu of ΦM waveform choices for your ΦMPath1
and
ΦMPath2 configurations. Select from sine, triangle, square, ramp, noise,
dual-sine, and swept-sine waveforms. Notice that your waveform selection
applies only to which ever
ΦM path configuration you have currently selected.
Softkey Location: Press
FM/ΦM hardkey, toggle FM/ΦM softkey to ΦM, press
More (1 of 2), ΦM Waveform
Status after Normal Preset: Sine
SCPI Commands:
[:SOURce]:PM[1]|2:INTernal[1]:FUNCtion:SHAPe?