HP ESG Series User Manual

5-189
Hardkey and Softkey Reference
Utility
Screen Saver Mode
This softkey toggles between Light Only and Light & Text mode for the screen
saver. When you set the screen saver to
Light Only, only the display light is turned
on and off. When you set the screen saver to
Light & Text, the display light and the
text are turned on and off.
Screen saver mode is a persistent state; it is not affected by an instrument preset or
by a power cycle.
Softkey Location: Press
Utility, Display, Screen Saver Mode
SCPI Commands:
:SYSTem:SSAVer:MODE LIGHt|TEXT
:SYSTem:SSAVer:MODE?
Screen Saver Off On
This softkey toggles the signal generator’s screen saver on and off. With the
screen saver on, the display is turned off after a period of time with no input from
the front panel. The display turns back on when any front panel key is pressed.
The screen saver is set to
Off at the factory. You can turn it on by pressing Utility,
Display Screen Saver. Each time you press Screen Saver Off On the selection
toggles between
Off and On.
You can adjust the screen saver mode to turn the light on and off or to turn both
the light and text on and off. Refer to the
Screen Saver Mode softkey description in
this section.
The screen saver delay is set to 1 hour at the factory. You can change the delay
time. Refer to the
Screen Saver Delay softkey description in this section.
Screen saver is a persistent state; it is not affected by an instrument preset or by a
power cycle.
Softkey Location: Press
Utility, Display, Screen Saver Off On
SCPI Commands:
:SYSTem:SSAVer:STATe ON|OFF|1|0
:SYSTem:SSAVer:STATe?

HP ESG Series Specifications

General

Brand	HP
Model	ESG Series
Category	Portable Generator
Language	English