6-3
Options and Accessories
Signal Generator Options
Move All Front Panel Connectors to Rear Panel (Option 1EM)
If you order Option 1EM at the point of sale, all of the front panel connectors will
be moved to the rear panel.
A post-sales retrofit kit is available to move your signal generator’s front panel
connectors to the rear panel. To order this kit after receipt of your signal generator,
request HP part number E4400-60027.
High Stability Timebase (Option 1E5)
If you order Option 1E5 at the point of sale, the standard timebase reference
assembly will be replaced with a high-stability timebase reference assembly. The
high-stability timebase reference assembly has improved specifications over the
standard assembly including warranted specifications for aging rate. (The aging
rate specification is typical for the standard assembly.) Refer to Chapter 9,
“Specifications,” for more information.
Delete Standard Manual Set (Option 0B0)
All instruments are supplied with one complete manual set (HP part number
E4400-90075) which includes the following documents:
• User’s Guide (HP part number E4400-90076)
• Programming Guide (HP part number E4400-90077)
• Quick Reference Guide (HP part number E4400-90078)
• Calibration Guide (HP part number E4400-90079)
If you order Option 0B0 at the point of sale, you will receive your signal generator
with no documentation. If you later decide to purchase the documentation, you
can order individual manuals by requesting the individual part numbers, or you
can order the complete manual set by ordering HP part number E4400-90075.
To Next Page
Loading...
Need help?
General
