HP ESG Series - LF out Tone 1 Freq

5-77
Hardkey and Softkey Reference
LF Out
LF Out Tone 1 Freq
Press this softkey to set the frequency for the LF Out tone 1. Enter the desired
frequency using the up and down arrow keys, the front panel knob, or enter a
value using the numeric keypad and press the
kHz or Hz terminator softkey. The
range of values allowed is 0.1 Hz through 50 kHz. The minimum increment
allowed is 0.1 Hz.
This softkey is coupled to the
LF Out Freq softkey in the initial LF Out Menu and
the
LF Out Start Freq softkey in the LF Out Swept-Sine Menu. Any value set for
LF Out Tone 1 Freq is reflected in the LF Out Freq and LF Out Start Freq softkeys.
Conversely, if you change the value for either the
LF Out Freq softkey or the
LF Out Start Freq softkey, the value for LF Out Tone 1 Freq is changed to match.
This softkey is only active when you have selected the internal source to operate
as a function generator.
Softkey Location: Press
LF Out, LF Out Source, Function Generator,
LF Out Waveform, Dual-Sine, LF Out Tone 1 Freq
Status after Normal Preset: 400.0 Hz
SCPI Commands:
[:SOURce]:LFOutput:FUNCtion:FREQuency <val><unit>
[:SOURce]:LFOutput:FUNCtion:FREQuency?