HP ESG Series - Scpi; Screen Saver Delay

5-188
Hardkey and Softkey Reference
Utility
SCPI
This softkey is one of the choices in both the Preset Language menu and the
Remote Language menu. Press either the
Preset Language softkey or the
Remote Language softkey to view these menus. SCPI (Standard Commands for
Programmable Instruments) is the language chosen for remote implementation of
all supported instrument features. Choosing
SCPI in the Preset Language menu
allows you to select this remote language as the default after a normal preset.
Choosing
SCPI in the Remote Language menu allows you to immediately change
the signal generator to use this remote language.
Softkey Location: Press
Utility, Power On/Preset, Preset Language, SCPI
or press
Utility, HP-IB/RS-232, Remote Language, SCPI
SCPI Commands:
:SYSTem:PRESet:LANGuage “SCPI”
:SYSTem:PRESet:LANGuage?
:SYSTem:LANGuage “SCPI”
:SYSTem:LANGuage?
Screen Saver Delay
This softkey sets the period of time before the screen saver is activated. The
screen saver delay is set to 1 hour at the factory. You can change the delay by
pressing
Utility, Display, Screen Saver Delay. The current value for delay is
displayed in the active entry area. To enter a new value, rotate the front panel
knob, use the up and down arrow keys, or enter the value using the numeric
keypad and press the
Enter terminator softkey. The range of values allowed is 1
through 12 hours in 1 hour increments.
Screen saver delay is a persistent state; it is not affected by an instrument preset or
by a power cycle.
Softkey Location: Press
Utility, Display, Screen Saver Delay
SCPI Commands:
:SYSTem:SSAVer:DELay <val>
:SYSTem:SSAVer:DELay?