HP ESG Series - Freq Multiplier

5-54
Hardkey and Softkey Reference
Freq
Softkey Location: Press Freq, Adjust Phase
Status after Normal Preset: 0 radians
SCPI Commands:
[:SOURce]:PHASe:[ADJust] <val><unit>
[:SOURce]:PHASe:[ADJust]?
Freq Multiplier
You can multiply the frequency shown on the display without changing the
frequency output at the RF OUTPUT connector (simulating the frequency at the
output of a harmonic multiplier). Press this softkey and enter a value from 1
through 50. Use the up and down arrow keys, the front panel knob, or enter a
value using the numeric keypad and press the
Enter terminator softkey. For
example, set the output frequency to 1 MHz. Then press
Freq, Freq Multiplier, 3,
Enter. The display will now show an output frequency of 3 MHz but the actual
output frequency will remain at 1 MHz. For any multiplier greater than 1, the
MULT indicator is shown in the frequency area of the display.
Softkey Location: Press
Freq, Freq Multiplier
Status after Normal Preset: 1
SCPI Commands:
[:SOURce]:FREQuency:MULTiplier <val>
[:SOURce]:FREQuency:MULTiplier?