HP ESG Series - Ext; Function Generator

5-69
Hardkey and Softkey Reference
LF Out
Ext
This softkey is one of the choices in the LF Output Sweep Trigger menu.
Choosing
Ext allows you to trigger swept-sine low frequency output using the
signal applied to the TRIGGER IN rear panel connector. Set the polarity of the
trigger signal using the
Trigger In Polarity Neg Pos softkey.
Softkey Location: Press
LF Out, LF Out Source, Function Generator,
LF Out Waveform, Swept-Sine, LF Out Sweep Trigger, Ext
Status after Normal Preset: LF output sweep trigger is set to Immediate
SCPI Commands:
[:SOURce]:LFOutput:FUNCtion:SWEep:TRIGger EXTernal
[:SOURce]:LFOutput:FUNCtion:SWEep:TRIGger?
Function Generator
This softkey lets you set the LF Out Source to be a function generator. You can
select a frequency and shape in addition to selecting the amplitude for a signal that
is output at the LF OUTPUT front panel connector. When you use the internal
source in this capacity, any modulation with the internal source selected is turned
off.
Softkey Location: Press
LF Out, LF Out Source, Function Generator
Status after Normal Preset: LF Out Source is set to Internal Modulation
SCPI Commands:
[:SOURce]:LFOutput:SOURce FUNCtion
[:SOURce]:LFOutput:SOURce?