6-2
Options and Accessories
Signal Generator Options
Signal Generator Options
This section describes the options available for your signal generator. You can
order these options with your signal generator by ordering the option number
shown, or you can order these options post-sales by requesting the HP part
number that is provided.
Front Handles (Option 1CN)
This kit contains two handles and the necessary hardware to attach the handles to
the front of the signal generator. Instructions for assembling the parts are included
with the kit. To order this kit after receipt of your signal generator, order HP part
number 5063-9227.
Rack Mount Flanges without Handles (Option 1CM)
This kit contains two flanges and the necessary hardware to rack mount the signal
generator in an HP System II or System II Plus cabinet. Instructions for
assembling the parts are included with the kit. To order this kit after receipt of
your signal generator, order HP part number 5063-9214.
Rack Mount Flanges with Handles (Option 1CP)
This kit contains two handles, two flanges, and the necessary hardware to rack
mount the signal generator in an HP System II or System II Plus cabinet.
Instructions for assembling the parts are included with the kit. To order this kit
after receipt of your signal generator, order HP part number 5063-9221.
Three Year Warranty (Option W30)
If you order Option W30 at the point of sale, you will receive a service contract
that extends your return-to-HP repair benefits beyond the end of the warranty
period for an additional two years. This additional support is not available as a
post-sales option.
To Next Page
Loading...
Need help?
General
