HP ESG Series - AM Tone 2 Rate; AM Waveform

5-11
Hardkey and Softkey Reference
AM
AM Tone 2 Rate
Press this softkey to set the internal modulation frequency for the AM tone 2.
Enter the desired rate using the up and down arrow keys, the front panel knob, or
enter a value using the numeric keypad and press the
kHz or Hz terminator softkey.
The range of values allowed is 0.1 Hz through 50 kHz. The minimum increment
allowed is 0.1 Hz.
This softkey is coupled to the
AM Rate softkey in the initial AM Menu and the
AM Stop Rate softkey in the AM Swept-Sine Menu. Any value set for
AM Tone 2 Rate is reflected in the AM Rate and AM Stop Rate softkeys. Conversely,
if you change the value for either the
AM Rate softkey or the AM Stop Rate softkey,
the value for
AM Tone 2 Rate is changed to match.
Softkey Location: Press
AM, AM Waveform, Dual-Sine, AM Tone 2 Rate
Status after Normal Preset: 400.0 Hz
SCPI Commands:
[:SOURce]:AM[1]|2:INTernal[1]:FREQuency:ALTernate <val><unit>
[:SOURce]:AM[1]|2:INTernal[1]:FREQuency:ALTernate?
AM Waveform
Pressing this softkey reveals a menu of AM waveform choices for your AM Path 1
and
AM Path 2 configurations. Select from sine, triangle, square, ramp, noise,
dual-sine, and swept-sine waveforms. Notice that your waveform selection
applies only to whichever AM path configuration you have currently selected.
Softkey Location: Press
AM, AM Waveform
Status after Normal Preset: Sine
SCPI Commands:
[:SOURce]:AM[1]|2:INTernal[1]:FUNCTion:SHAPe?