5-127
Hardkey and Softkey Reference
Pulse
Pulse
Pressing the front panel Pulse key reveals a menu of softkeys. These softkeys are
described in this section in alphabetical order.
Ext2 DC-Coupled
This softkey lets you input an external, DC-coupled, pulse modulation signal to
the EXT 2 INPUT connector.
The external 2 input has multiple uses but can be used for only one modulation at
a time. If, for example you were using the external 2 input in a frequency
modulation configuration for
FM Path 1, and then you configured the pulse
modulation source to also use the external 2 input, the signal generator would turn
off
FM Path 1 and assign the external 2 input to your pulse configuration.
Softkey Location: Press
Pulse, Pulse Source, Ext2 DC-Coupled
Status after Normal Preset: Pulse Source is set to Internal Square
SCPI Commands:
[:SOURce]:PULM:SOURce EXTernal2
[:SOURce]:PULM:SOURce?
To Next Page
Loading...
